單項選擇題When an IP packet is Layer 3-switched from a source in one VLAN to a destination in another VLAN,which field in a packet will be rewritten? ()

A. Layer 2 TTL
B. Layer 3 TTL
C. Layer 3 source address
D. Layer 3 transport protocol
E. Layer 3 destination address


您可能感興趣的試卷

你可能感興趣的試題

1.單項選擇題On a Cisco Catalyst switch, which configuration command is used to apply a VACL named "test" to filterthe traffic within VLAN100? ()

A.interfacevlan100ipaccess-grouptest
B.interfacevlan100ipaccess-grouptestin
C.interfacevlan100ipaccess-grouptestout
D.vlanfiltertestvlan-list100
E.vlanaccess-maptest100

2.單項選擇題When you enter the interface command auto qos voip cisco-phone on a port at the edge of a network,how does the Cisco Catalyst switch detect if a Cisco IP Phone is connected to the port?()

A. by snooping the CoS marking on the incoming frames
B. by using RTP hello messages between the switch port and the Cisco IP Phone
C. by using CDP
D. by using DHCP snooping
E. by snooping the incoming 802.1Q VLAN tag


4.單項選擇題What is a primary objective of the security architecture assessment? ()

A. document power and UPS availability
B. to integrate routing and switching components
C. create a design specification document
D. document the customer's current and future technology projects

5.單項選擇題What is the final step of the core baselining process?()

A. Implement threshold monitoring using RMON.
B. Implement monitoring using SNMP or RMON.
C. Poll and record specific SNMP MIB objects from the device.
D. Verify that SNMP MIB is supported in the relevant core device.

最新試題

Referring to the partial Cisco Catalyst switch configuration shown, which two of these statements are correct? ()(Choose two.)

題型:多項選擇題

In a high-availability network, which command, when placed on ports that have connected end stations, will allow you to prevent delays in service for end stations by placing a port in blocking mode?()

題型:單項選擇題

Which configuration will enable OSPF for IPv6 on FastEthernet 0/0/0?()

題型:單項選擇題

Refer to the exhibit. Which two of these statements are correct? (Choose two.)()

題型:多項選擇題

Which Cisco IOS command is used to troubleshoot a problem in which a BGP session stays in the active state?()

題型:單項選擇題

As a network administrator, you issue the interface auto qos voip cisco-phone command on a port in an edge network. It is possible for a Cisco Catalyst switch to check if a Cisco IP Phone is directly attached to that port by:()

題型:單項選擇題

Refer to the exhibit. For the given configuration, on packets leaving the router on interface FastEthernet0/0 that matches the high traffic class, what will the MPLS experimental bit be set to?()

題型:單項選擇題

On the Catalyst 6500 Series switch, which command is used to establish a console connection to the Firewall Services Module?()

題型:單項選擇題

Refer to the exhibit. You want to minimize the downtime that results from supervisor engine switchovers on Cisco 6500 Series Switches and Cisco 7600 Series Routers. To achieve this, you are considering deploying a Cisco Nonstop Forwarding with Stateful Switchover solution using OSPF.In the exhibit you can see the output of the show ip ospf neighbor detail command.Which trait of systems using Cisco Nonstop Forwarding with Stateful Switchover and OSPF is shown in the exhibit output and will impact your plan?()

題型:單項選擇題

What is the most likely reason that an IBGP route that has been selected as a best route is not entered into the IP routing table?()

題型:單項選擇題