A.less than 10 percent
B.10 to 15 percent
C.15 to 20 percent
D.25 to 30 percent
您可能感興趣的試卷
你可能感興趣的試題
A.Class A
B.Class 1
C.Class 2
D.Class 3
E.Class 4
A.5 to 10 percent for both 2.4 GHz and 5 GHz
B.10 percent for both 2.4 GHz and 5 GHz
C.20 percent for 2.4 GHz and 15 to 20 percent for 5 GHz
D.20 percent for 2.5 GHz and 10 percent for 5 GHz
A.1， 4， 7， 11
B.1， 4， 8. 11
C.1， 6， 11， 1
D.2， 4， 6， 8
A.AP1130
B.AP1242
C.AP1252
D.BR1310
A.Cisco WCS supports third-party antennas for location applications.
B.Access points that are defined with third-party antennas will not participate in rogue on-demand location tracking.
C.Cisco WCS supports third-party antenna gain， azimuth， and elevation progation patterns.
D.Access points that are defined with a third-party antenna in Cisco WCS will display coverage heat maps.
最新試題
Which antenna generally has the narrowest first Fresnel zone in both the horizontal and verticalplanes？（）
When planning for voice deployments with the Cisco Unified Wireless IP Phone 7921G handset in amultifloor building with a WLAN that operates at an 11 MB/s data rate， how many decibelsreferenced to 1 milliwatt of same-channel separation are recommended between floors？（）
The Cisco Aironet 1140 Series Access Point draws 12.95 W at the power source. However， whenusing a long Ethernet cable， the device can draw up to how much additional wattage？（）
Which three formats can be used to import floor maps in Cisco WCS v5.2？（）
What should be done if Cisco Spectrum Expert Wi-Fi reports a channel utilization of 40 percent onchannel 36， from a source outside of the site？（）
Cisco recommends a decibel referenced to 1 milliwatt signal level for the coverage cell edge at thepredetermined data rate that is needed to support the VoWLAN device and call capacityrequirements. What is that signal level value for Cisco Unified Wireless IP Phones 7920， 7921G， and7925G？（）
When surveying for VoWLAN， which power level should you base the access point coverage designon？（）
Which can NOT be selected for supported services in Cisco WCS Planning Tool？（）
Which two Cisco antennas provide better isolation from RF sources that might be located behindthe antennas？（）
When planning for VoWLAN capacity during a site survey， how many simultaneous calls can beestimated per 5 GHz channel？（）