A.Bluetooth
B.frequency hopping
C.microwave oven
D.802.11b client card
E.802.11b access point
您可能感興趣的試卷
你可能感興趣的試題
A.ISM 2.4 GHz
B.ISM 900 MHz
C.ISM 5 GHz
D.public safety 4.9 GHz
E.GSM 1.9 GHz
A.data/coverage
B.location with Monitor Mode access points
C.demand
D.high density
A.100 mW， 24 Mb/s
B.100 mW， 18 Mb/s
C.25 mW， 18 Mb/s
D.3.2 mW， 54 Mb/s
A.In a multifloor building， the access point layout from the survey of one floor can be directly applied to the remaining floors
B.Access points can be installed in the same place on every floor， without worrying about co-channelinterference
C.You can survey with a Cisco AIR-ANT5959 in a plenum environment
D.Identify all hazardous and restricted areas that might require extra or special survey and installationwork
A.Active mode does not require the client to be specifically confgured
B.Passive mode can survey more than one access point at a time
C.Active mode yields signal-quality information such as packet retries and lost packets
D.Active mode requires more time to survey but yields more information results than passive mode does
最新試題
Cisco recommends a decibel referenced to 1 milliwatt signal level for the coverage cell edge at thepredetermined data rate that is needed to support the VoWLAN device and call capacityrequirements. What is that signal level value for Cisco Unified Wireless IP Phones 7920， 7921G， and7925G？（）
A design requires 100 access points with high channel bandwidth and disabled lower data rates.How are the data rates set on the Cisco WLC and Cisco WCS？（）
Which three formats can be used to import floor maps in Cisco WCS v5.2？（）
Which statement about active and passive surveys is incorrect？（）
Which three device types are identified by Cisco Spectrum Expert Wi-Fi finding an Avg PulseDuration parameter？（）
In an outdoor bridge link， what is calculated by using this formula： transmitter power + antennagain - insertion OR cable loss（）？
What does a broad-spectrum interferer lower？（）
When planning for voice deployments with the Cisco Unified Wireless IP Phone 7921G handset in amultifloor building with a WLAN that operates at an 11 MB/s data rate， how many decibelsreferenced to 1 milliwatt of same-channel separation are recommended between floors？（）
Which two methods can be used to prevent or reduce RFI from colocated directional antennas（）
Which three items should the site survey documentation include？（）