A. Shared
B. Point-to-Point
C. Designated
D. Multiaccess non-broadcast
您可能感興趣的試卷
你可能感興趣的試題
As an experienced network engineer, you are asked to troubleshoot a CIS network outage. During the troubleshooting process, you notice that one of your colleagues connects additional devices to the network with the use of his own switch. With the purpose of improving speed, the switch is attached to both network ports in an office, which leads to bridge loop.
Enabling which of the following feature will be able to prevent this problem from happening again?（）
A.GLBP
B.RSTP
C.BPDU guard
D.root guard
A. Disables the interfaces to prevent traffic flow
B. Clears all the configurations on the interface
C. Switches the port from access mode to trunk mode
D. Converts the port from physical Layer 2 port to physical Layer 3 port
A.9
B.3
C.12
D.6
A. using DHCP snooping
B. snooping the incoming 802.1Q VLAN tag
C. using CDP
D. snooping the CoS marking on the incoming frames
A. Route reflectors are not passing updates properly.
B. BGP synchronization has been enabled.
C. The next-hop address is unreachable.
D. No loopback interface has been configured on a router.
最新試題
What is the purpose of using VPN hardware acceleration equipment?（）
What is the function of the no switchport catalyst switch interface configuration command?（）
In a high-availability network, which command, when placed on ports that have connected end stations, will allow you to prevent delays in service for end stations by placing a port in blocking mode?（）
Which Cisco IOS command is used to troubleshoot a problem in which a BGP session stays in the active state?（）
As an experienced network engineer, you are asked to troubleshoot a CIS network outage. During the troubleshooting process, you notice that one of your colleagues connects additional devices to the network with the use of his own switch. With the purpose of improving speed, the switch is attached to both network ports in an office, which leads to bridge loop.Enabling which of the following feature will be able to prevent this problem from happening again?（）
Refer to the exhibit. Which two of these statements are correct? (Choose two.)（）
Which command is used to view IPv6 parameters related to the BGP process?（）
Referring to the partial Cisco Catalyst switch configuration shown, which two of these statements are correct? （）(Choose two.)
What is the maximum number of Cisco Catalyst 3750 Series Switches that can be united into a single manageable unit using the Cisco StackWise technology?（）
What is the most likely reason that an IBGP route that has been selected as a best route is not entered into the IP routing table?（）