You are troubleshooting a one-way call problem with a Cisco 7920 wireless IP phone on a standaloneWLAN.
What may have caused this problem？（）
A.The minimum data rate is not set to 11 Mbps.
B.An address resolution protocol has been disabled.
C.Publicly Secure Packet forwarding is enabled.
D.The access point is set to the least congested channel.
您可能感興趣的試卷
你可能感興趣的試題
You are troubleshooting a problem with a Cisco 7920 wireless IP phone that is causing the
phone to drop calls. The problem appears to be a roaming bandwidth issue. In order to verify what kind ofissue it is， you decide to increase the bandwidth reserved for roaming on the WLAN controller to themaximum.
What level do you set the bandwidth to？（）
A.5 percent
B.15 percent
C.25 percent
D.35 percent
You have very few Cisco 7920 wireless IP phones on your network， but lots of wireless laptops. You want toincrease the bandwidth available for the laptops by decreasing the bandwidth reserved for the Cisco 7920phones.
What is the lowest percentage of voice-allocated bandwidth you can select on the WLANcontroller？（）
A.25 percent
B.40 percent
C.55 percent
D.75 percent
A.55 percent
B.56 percent
C.75 percent
D.85 percent
A.6 percent
B.12 percent
C.18 percent
D.24 percent
When configuring a WLAN controller for a voice application using Cisco 7920 wireless IP phones.
Which two general control settings should you select？ （）
A.Aggressive Load Balancing on
B.Aggressive Load Balancing off
C.Multicast on
D.Multicast off
E.AP Fallback on
F.AP Fallback off
最新試題
You have been called upon to add location-based services into an existing controller-basedwireless design which primarily encompasses handheld devices such as barcode scanners and Cisco7920 wireless IP phones.In which mode should you deploy the additional access points to achievethe density required without excessive co-channel interference？（）
You are installing a Cisco 4402 Series Wireless LAN Controller.What type of interface is used on the uplink port？（）
Clients using Cisco-LEAP and EAP-FAST authentication are having no problems logging on to thewireless network， but clients using PEAP are failing to log on.Which situation would result in thistype of problem？（）
You are installing a Cisco Aironet 1000 Series controller-based access point. When you boot it， allthe LEDs on the access point blink together.What does this indicate about the access point？（）
When configuring a WLAN controller for a voice application using Cisco 7920 wireless IP phones，which two general control settings should you select？（）
A mobility group is created by a Cisco WLCM and 4402 Series Wireless LAN Controller. A client thatis anchored on the Cisco WLCM roams to an access point on the 4402 controller. You then run adebug command on the 4402 controller.Which message would best describe the establishment ofthe tunnel from the foreign controller’s perspective？（）
The Cisco Wireless Location Appliance provides an audit trail for each device tracked for up to how many days？（）
How many WLANs can a Cisco Aironet 1242 in H-REAP mode support when actively connected toa wireless controller？（）
You are trying to change the polling parameters used by the location manager via the Cisco WCS，and your request is being denied. What is wrong？（）
You are troubleshooting a problem with a Cisco 7920 wireless IP phone that is causing the phoneto drop calls. The problem appears to be roaming bandwidth issue. In order to verify what kind ofissue it is， you decide to increase the bandwidth reserve for roaming on the WLAN controller tomaximum.What level do you set the bandwidth to？（）