A.Frame Monitoring
B.Radio Scan
C.Self-Healing
D.Client Walkabout
您可能感興趣的試卷
你可能感興趣的試題
You are trying to deploy a configuration job to an IOS access point using the WLSE， but the jobfails.
Which of the following would cause this failure？（）
A.SNMP communities
B.Telnet/SSH user/password
C.WLCCP credentials
D.HTTP user/password
A.3
B.1
C.4
D.6
A.PSK authentication
B.EAP authentication
C.WPA authentication
D.Web authentication
VLANs have been enabled on an autonomous access point.
In order for clients associating toVLANs other than the native VLAN to receive an IP address which of the following must beconfigured？（）
A.access point Ethernet port set to SSL trunking
B.switchport set to 802.1q trunking
C.switchport set to SSL trunking
D.access point Ethernet port not set to 802.1q trunking
A.router（config）# wlccp authentication-server infrastructure eap Group_1
B.router（config）# wlccp authentication-server infrastructure eap-fast Group_1
C.router（config）# wlccp authentication-server client eap-fast Group_1
D.router（config）# wlccp authentication-server client eap Group_1
最新試題
You are troubleshooting a problem with a Cisco 7920 wireless IP phone that is causing the phoneto drop calls. The problem appears to be roaming bandwidth issue. In order to verify what kind ofissue it is， you decide to increase the bandwidth reserve for roaming on the WLAN controller tomaximum.What level do you set the bandwidth to？（）
Which of the following parameter sets must be configured on the Cisco Wireless Location Appliance？（）
You are using ADU and are authenticated and associated to an access point. However， you are unable to obtain an IP address.Which of these has caused this problem？（）
You are installing a Cisco Aironet 1000 Series controller-based access point. When you boot it， allthe LEDs on the access point blink together.What does this indicate about the access point？（）
A Cisco WCS version 4.0 has been installed on a server with a dual Pentium 3.0 GHz processor，4GB RAM， and an 80 GB hard drive. A location appliance has been incorporated into the networkand is being monitored by the Cisco WCS. There are 3000 devices to be tracked but not all of themare being tracked on the Cisco WCS.What can be done to correct the problem？（）
A client roams from H-REAP AP1 to H-REAP AP2. The client is unable to associate to H-REAP AP2.H-REAP AP2 has six other clients associated to it， which continue to pass traffic.What has causedthis problem？（）
You want to dynamically assign users to an 802.1Q VLAN as a result of their authentication. Inorder to accomplish this.Which two IETF RADIUS attributes should you configure on the CiscoSecure ACS？ （）
When configuring a WLAN controller for a voice application using Cisco 7920 wireless IP phones，which two general control settings should you select？（）
When configuring Cisco Secure ACS to support wireless EAP authentication， which device must be configured as a AAA client？（）
An REAP was supporting 16 WLANs， but now it only supports one.What happened to cause the change？（）