An 802.1X client cannot authenticate to an autonomous access point configured for multiple
VLANs. The native VLAN does not have an SSID configured.
Which one of the following links being down would prevent the clients from authenticating？（）
A.between the RADIUS and the access point
B.between the client’s VLAN and the WLSE
C.between the native VLAN and the WLSE
D.between the client’s VLAN and the RADIUS
您可能感興趣的試卷
你可能感興趣的試題
In a deployment using the lightweight access points， clients set up to authenticate with EAP-PEAPor EAP-Cisco Wireless （LEAP） cannot authenticate. Upon inspection of the Failed Attempts reportyou see the following error： "Unknown network access server NAS."
What two problems can causethis type of failure？（）
A.misconfigured IP address of the AAA server on the wireless controller
B.misconfigured IP address of the wireless LAN controller on the AAA server
C.misconfigured EAP type on the wireless LAN controller
D.misconfigured shared secret on the wireless LAN controller
E.misconfigured EAP type on the AAA server
Your client has deployed a Cisco Wireless Location Appliance within their warehouse environment.They have been experiencing problems with tracking objects using active RFID tags. The RFID tagdata is not being collected.
On which device would you verify that RFID status has been enabled？（）
A.Cisco WCS
B.access point
C.wireless controller
D.location manager
A.802.11b/g
B.radio
C.access point
D.802.11a
A.IP
B.TCP
C.UDP
D.IPX
Your client has deployed a Cisco Wireless Location Appliance within their warehouse environment.They have been experiencing problems with tracking objects using active RFID tags. The RFID beacon rate is 10 seconds. You have discovered an issue with the RFID timeout value.
How shouldthis value be changed？（）
A.Change the value on the wireless controller to 45 seconds.
B.Change the value on the wireless controller to 95 seconds.
C.Change the value on the Cisco WCS to 95 seconds.
D.Change the value on the Cisco WCS to 45 seconds.
最新試題
You are installing a Cisco Aironet 1000 Series controller-based access point. When you boot it， allthe LEDs on the access point blink together.What does this indicate about the access point？（）
Static WEP is configured on the access point. You are authenticated and associated to the accesspoint but are unable to obtain an IP address.Which of the following will cause this problem？（）
You are trying to change the polling parameters used by the location manager via the Cisco WCS，and your request is being denied. What is wrong？（）
Which of the following commands on the wireless interface of a Cisco 3845 Integrated Service Router allows the SSID to broadcast？（）
You are configuring an RF group of controllers that coordinate Radio Resource Management calculations.What is the maximum number of WLAN controllers that you can add？（）
You are using ADU and are authenticated and associated to an access point. However， you are unable to obtain an IP address.Which of these has caused this problem？（）
The IOS of a North American Cisco Aironet 1130AG Series standalone access point has becomecorrupt. You must therefore reload the TFTP firmware.Before you press and hold the MODEbutton， you should verify that the file name is which of the following？（）
When configuring a WLAN controller for a voice application using Cisco 7920 wireless IP phones，which two general control settings should you select？（）
An REAP was supporting 16 WLANs， but now it only supports one.What happened to cause the change？（）
You are troubleshooting a problem with a Cisco 7920 wireless IP phone on a standalone WLAN.The phone rings but， when you answer， the call is dropped.What may cause this problem？（）