A. SDH circuit over a SONET network delivering it as an SDH signal
B. SDH circuit over a SONET network delivering it as a SONET signal
C. SONET circuit over an SDH network delivering it as an SDH signal
D. SONET circuit over an SDH network delivering it as a SONET signal
您可能感興趣的試卷
你可能感興趣的試題
A. trunking
B. squelching
C. nodal bypass
D. bridge and roll
E. node failure insertion
A. Traffic is switched from the first node receiving the AIS indication.
B. Traffic is switched from the far side of the failure, allowing handshaking to occur.
C. UPSR traffic is switched from the terminating node, BLSR traffic is rerouted from the originating node in the ring.
D. UPSR traffic is switched from the terminating node, circuit by circuit. BLSR traffic is rerouted from the last reachable node in the ring.
A. Each fiber has half of its SONET capacity reserved for protection.
B. Two fibers in the span carry working traffic, while the other two fibers in the span are reserved for protection.
C. The signal is sent simultaneously in both directions around the ring. The receiver determines which fiber to listen to based on signal quality.
D. The signal is sent simultaneously in both directions around the ring. The transmitter determines which fiber has the working bit set for the receiver to acknowledge.
A. DS-1; E1
B. DS-1; STM-1
C. OC-3; STM-1
D. STS-1; STM-1
E. OC-192; STM-192
A.AMI
B.ESF
C.DUS
D.SSM
E.B3ZS
F.B8ZS
最新試題
Which timing mode is appropriate for a SONET NE that is adjacent to a SONET NE using BITS-1 timing source?（）
A Channel ID mismatch occurs when （）.
Scrambling of SONET signals is done to （）.
UPSR protection switching is initiated by （）, while BLSR is initiated by （）.
If the dispersion of a given fiber is 17ps/nm*km at 1550 nm and zero at 1310 nm, then what is the accumulated dispersion of an ITU wavelength after it travels 200 km?（）
What are three relevant design considerations when using the 15216 EDFA? （）(Choose three.)
Click the Exhibit button. Given the following parameters: transmitter output (min): -2 dBm receiver input (min): -28 dBm 15216 Mux and Demux loss: 4.5 dB 16 channels maximum In which sites shown in the exhibit could the 15216 EDFAs be placed to minimize the number of EDFAs needed?（）
Click the Exhibit button. Which type of multiplexer is shown in the exhibit?（）
Why are the 1300 nm and 1550 nm regions of the fiber spectrum primarily used for optical communications?（）
What is an advantage of an externally modulated laser over a directly modulated laser?（）