A.take no measures
B.extinguish the fire as soon as possible
C.feed water to the boiler
D.open the blow down valve
您可能感興趣的試卷
你可能感興趣的試題
A.feed pump suction line
B.hot well
C.shell of the feed heater
D.feed lines to the boiler
A.rise when the steam pressure is increased
B.remain constant as long as the feed pump operates
C.fall when the steam pressure is decreased
D.vary as the steam demand changes
A.to raise water level
B.only while making steam
C.to remove scum
D.when fire are secured
A.drop as the boiler warms up
B.rise as the boiler warms up
C.remain unchanged until the boiler is hot enough
D.rise and fall with the steam demand
A.filled with water
B.purged
C.cleared of air
D.None of the above is true
最新試題
An increasing head pressure in a refrigeration system, without any corresponding change in the cooling water inlet temperature, would probably be caused by （）.
Thermostatic expansion valves can be adjusted for （）.
The usual symptoms of cavitation in a centrifugal pump is （）.
If you are given the job of adding hydraulic fluid to a mooring winch, and are not certain as to the type of fluid to use, you should （）.
The major source of chemical contaminants in hydraulic fluid is （）.
A salinity indicator is used to determine the （）.
Which of the problems listed would came the discharge temperature of an R-12 refrigeration compressor to increase?（）
The amount of fluid friction or internal friction inherent in a mineral lubricating oil is reflected as a measure of its （）.
The rate of heat transfer between the hot and cold fluids passing through a shell-and-tube type heat exchanger will （）.
Pitting in the suction areas of a centrifugal pump bronze impeller is usually caused by （）.