A.strangers
B.relief valves
C.emergency valves
D.strainers
您可能感興趣的試卷
你可能感興趣的試題
A.proceeding
B.overloading
C.collision
D.flooding
A.every oil tanker
B.every ship of 400 tons gross tonnage and above
C.A and B
D.Neither A nor B
A.Non automatic discharge overboard of machinery space bilge water
B.Automatic discharge overboard of machinery space bilge water
C.A and B
D.Neither A nor B
A.open
B.close
C.remain in its position
D.flood the evaporator with refrigerant
A.low water level
B.low oil pressure
C.excessively high fuel pressure
D.an improper air/fuel ratio
最新試題
If you are given the job of adding hydraulic fluid to a mooring winch, and are not certain as to the type of fluid to use, you should （）.
The control mode in which the final control element is moved from one of two flexed positions to the other is known as （）.
Which of the following problems could cause the high pressure cutout switch to shut down the compressor in a refrigeration system?（）
When a refrigeration compressor has developed a high head pressure as a result of a refrigerant overcharge, you should （）.
The rate of heat transfer between the hot and cold fluids passing through a shell-and-tube type heat exchanger will （）.
The amount of fluid friction or internal friction inherent in a mineral lubricating oil is reflected as a measure of its （）.
Which of the problems listed would came the discharge temperature of an R-12 refrigeration compressor to increase?（）
Pitting in the suction areas of a centrifugal pump bronze impeller is usually caused by （）.
If the relief valve on the discharge side of a hydraulic pump lifts, the cause could be （）.
A salinity indicator is used to determine the （）.