A.fluid friction
B.fluid turbulence
C.component misalignment
D.pressure surges
您可能感興趣的試卷
你可能感興趣的試題
A.refrigerant must be bled off the sensing line before adjustments are made
B.all refrigerant must be pumped into the receiver before adjustments are made
C.time must be allowed for conditions to stabilize in the evaporator before further adjustments are made
D.all refrigerant must be routed through the dehydrator while changing the superheat setting
A.motor controller overload would open
B.pump would eventually overheat
C.relief valve would continuously cycle open
D.motor would overheat
A.have a greater head capacity
B.operate with increased impeller efficiency
C.discharge through the suction side of the pump casing
D.require more power to run the shaft
A.hydraulic fluid contamination
B.excessive fluid friction
C.turbulent fluid flow
D.fluid pressure surges
A.yearly
B.quarterly
C.monthly
D.daily
最新試題
On tank vessels equipped with power operated cargo tank valves, the type of power operator most commonly used is （）.
The rate of heat transfer from a hot region to a cold region is affected most by the （）.
When a refrigeration compressor has developed a high head pressure as a result of a refrigerant overcharge, you should （）.
A salinity indicator is used to determine the （）.
The major source of chemical contaminants in hydraulic fluid is （）.
Which of the following problems could cause the high pressure cutout switch to shut down the compressor in a refrigeration system?（）
Which of the problems listed would came the discharge temperature of an R-12 refrigeration compressor to increase?（）
The control mode in which the final control element is moved from one of two flexed positions to the other is known as （）.
Thermostatic expansion valves can be adjusted for （）.
The amount of fluid friction or internal friction inherent in a mineral lubricating oil is reflected as a measure of its （）.