A.compressor is overloaded
B.motor is overloaded
C.foundation bolts are loose
D.belts are too tight
您可能感興趣的試卷
你可能感興趣的試題
A.rapidly
B.by gravity
C.through a standard orifice at a specified temperature
D.at a rate of 60cc per second
A.flooding back
B.superheating
C.overflowing
D.recycling
A.Absorb erosion of high velocity discharge stream
B.Seal pump shaft against entry of air
C.Isolate the discharge side from the suction side
D.Dampen the turbulent discharge flow
A.cooling only
B.cooling and humidifying
C.cooling and dehumidifying
D.adiabatic cooling
A.Sea water is heated to boiling temperature while under a vacuum
B.Sea water is passed over heated plates in a thin film
C.Heated sea water is injected into a vacuum chamber
D.Sea water is forced through a heated eductor
最新試題
The amount of fluid friction or internal friction inherent in a mineral lubricating oil is reflected as a measure of its （）.
Pitting in the suction areas of a centrifugal pump bronze impeller is usually caused by （）.
On tank vessels equipped with power operated cargo tank valves, the type of power operator most commonly used is （）.
The temperature differential occurring between the inlet temperature of the fluid to be cooled and the outlet temperature of the cooling medium in a shell-and-tube heat exchanger is greatest in which of the flow designs listed?（）
A gradual decrease in the discharge pressure of an operating hydraulic pump can be caused by （）.
An excessive charge of refrigerant in an air-cooled refrigeration system can cause （）.
A salinity indicator is used to determine the （）.
When the steering gear is in operation, you should （）.
Low compressor head pressure in a refrigeration system can be caused by（）.
The usual symptoms of cavitation in a centrifugal pump is （）.