A.too light of a load
B.injection timing is too early
C.overloading of the engine
D.too low of a compression ratio
您可能感興趣的試卷
你可能感興趣的試題
A.caused by retarded injection timing
B.caused by a mechanical defect in one cylinder
C.caused by high fuel injection pressures
D.normal for these conditions
A.an air bound fuel system
B.damage to cylinder heads and pistons
C.excessive fuel injection
D.excessive air valve lift
A.excessive fuel oil temperature
B.long periods of engine overload
C.metallic contact between nozzles and cylinder heads
D.hard carbon deposit and varnish on the nozzles
A.opposed to the crankshaft rocking couple
B.resonant with the crankshaft natural frequency
C.critical fore and aft crankshaft vibrations
D.horizontal whipping motions of the crankshaft
A.cylindrical in shape with service connections located at the top and bottom
B.opened and made available for inspection during biannual inspections provided
C.with automatic drain traps for the removal of moisture
D.so installed as to make the drain connections effective under extreme conditions of trim
最新試題
As soon as a diesel engine has started, which of the listed engine operating parameters should be checked FIRST?()
When does auxiliary burner of incinerator put into operation? ()Ⅰ. start incinerator when it is coldⅡ. the sludge for dealing with is littleⅢ. the sludge for dealing with is largeⅣ. the water and impurity in sludge are too muchⅤ. the temperature in incinerator is lowⅥ. dealing with little solid rubbish
If separating effect is not good, which measure should be taken ()
The cetane rating of diesel fuel is an indication of the ()
If two A.C.generators are to be operated in parallel, the load is distributed evenly by()
Using a file without a handle may result in ()
The main purpose of port State control is not to()
A purge recovery system is used in a centrifugal air conditioning or refrigeration system to ()
The flash point of a residual fuel oil should be used to determine the highest temperature to which oil may be heated()
Thermostatic steam pressure reducing valves are used in the fuel oil service system to control the()