A.Air filters
B.Fuel oil strainers
C.Crank case oil level
D.Pyrometer readings
您可能感興趣的試卷
你可能感興趣的試題
A.increases the density of the air
B.decrease the density of the air
C.increases the specific heat of the air
D.decreases the specific heat of the exhaust
A.The direction of pressure on the journal in four-stroke engine is continuously
B.positive feed lubricators are installed on all bearings of four-stroke engine, whereas as a splash feed system is used on tow-stroke engine
C.four-stroke engines usually utilize a heavier grade of oil than tow-stroke engines
D.Low-stroke engines usually consume less lube oil than four-stroke engines
A.overheated injection pumps
B.water condensed in the cylinders
C.fuel dilution of the lube oil
D.air in the fuel system
A.check the pyrometer readings
B.check the crankcase oil level
C.check the fuel oil strainers
D.clean the fuel system
A.carbonization of oils from the combustion chambers
B.emulsions of lube oil and water
C.coagulation of unburned fuel below the piston rings
D.all of the above
最新試題
The additional mark ()in the Classification Certificate for Machinery means propulsion apparatus is remotely controlled on the navigating bridge control station, and engine assembly control station is unmanned periodically.
The shipboard oil pollution emergency plan will be invalid after ()
Which one is NOT the ‘clear grounds’ for a more detailed inspection?()
Thermostatic steam pressure reducing valves are used in the fuel oil service system to control the()
Under MARPOL Code the ship to which it applies has to carry ()
To shut down a diesel engine after it exceeds the set maximum speed,which type of device listed should be used?()
Flame failure in an automatically fired auxiliary boiler can from a/an ()
One of the reasons that cause oil flowed from sludge outlet of a self-cleaning separator is()
The Port State Control officer may witness a fire drill carried out by the crew assigned to these duties on the()
By comparing the exhaust gas temperature of each cylinder, the operator can determine if the load is balanced throughout the engine. The device most commonly used is a()