A.install oversized rings
B.hone the cylinder liner to allow ring installation
C.compress the rings tighter with a compressing tool
D.file the ends of the rings
您可能感興趣的試卷
你可能感興趣的試題
A.jam in the most worn part of the cylinder when the rings expand
B.break in the most worn part of the cylinder when the rings expand
C.wear eccentrically on the side opposite the end gap
D.overheat and jam at the top center on the combustion stroke
A.prevent governor surging at shutdown
B.make sure the fuel nozzles are flushed clean
C.prevent pressure buildup in the fuel lines
D.prevent damage from localized overheating
A.stop the combustion air supply
B.engage the jacking gear
C.secure the lube oil pump
D.shut off the fuel at the day tank
A.They conduct heat poorly
B.They are expensive
C.They cannot be replaced
D.They require special tools for removal
A.The diesel oil must never be allowed to mix with the heavy fuel
B.The temperature of the fuel from the pre–heater should be gradually reduced after switching over the three–way valve
C.The heating steam to the pre-heater should be secured as soon as the diesel fuel passes through the three-way valve
D.The heating steam must be secured before the diesel oil passes through the three-way valve
最新試題
If separating effect is not good, which measure should be taken ()
The treatment of the fuel oils involves storage, heating, filtering and()
To shut down a diesel engine after it exceeds the set maximum speed,which type of device listed should be used?()
Thermostatic steam pressure reducing valves are used in the fuel oil service system to control the()
The shipboard oil pollution emergency plan will be invalid after ()
Refrigerant entering the compressor of a refrigeration system should be in which of the following conditions?()
The flash point of a residual fuel oil should be used to determine the highest temperature to which oil may be heated()
Using a file without a handle may result in ()
()are used to digest the sewage to produce innocuous sludge in a biological sewage treatment plant.
One of the reasons that cause oil flowed from sludge outlet of a self-cleaning separator is()