A.worn valve seats
B.worn main bearing
C.excessive valve clearance
D.weak rocker arm springs
您可能感興趣的試卷
你可能感興趣的試題
A.spark from a plug in the pre-combustion chamber
B.electrical discharge from the distributor
C.heat of compression within the cylinder
D.heat from the fuel injection nozzle
A.engine operating speed
B.an air manifold
C.a hydraulic distributor
D.individual cams and valve gear
A.the air start valve timing gears and rods
B.a cylinder check valve
C.individual cams and valve gear
D.an air manifold poppet valve
A.degree of cylinder air turbulence
B.firing pressure in the engine
C.quality of fuel to be injected
D.duration of the ignition delay period
A.laying a straight edge across the crank webs at the crankpin and measuring the distance to the crankpin in two places
B.measuring the crank drop on either side of each crank throw while the crankshaft is slowly rotated through one revolution
C.rotating the crankshaft through one revolution, pausing each 90oof rotation to measure bearing clearances, top and bottom
D.taking micrometer reading between the crank cheeks opposite the crankpin every 90°of crank angle rotation
最新試題
As soon as a diesel engine has started, which of the listed engine operating parameters should be checked FIRST?()
The condensers located in various stages of a flash evaporator are cooled by()
Thermostatic steam pressure reducing valves are used in the fuel oil service system to control the()
Engine parameters shall be corresponded to NOx Technical Files. This is required by ()
A purge recovery system is used in a centrifugal air conditioning or refrigeration system to ()
If separating effect is not good, which measure should be taken ()
One of the reasons that cause oil flowed from sludge outlet of a self-cleaning separator is()
To shut down a diesel engine after it exceeds the set maximum speed,which type of device listed should be used?()
() is not installed on the main switchboar.
By comparing the exhaust gas temperature of each cylinder, the operator can determine if the load is balanced throughout the engine. The device most commonly used is a()