A.insufficient fuel supply due to fuel pump valves sticking or leaking
B.excessive mechanical clearance between the piston crown and cylinder head
C.excessively worn fuel pump plunger
D.excessive exhaust back pressure
您可能感興趣的試卷
你可能感興趣的試題
A.detecting faulty combustion in individual cylinders
B.adjusting fuel racks to maintain equal loading between cylinders
C.adjusting the load limit setting of the governor at idle conditions
D.calculating engine horsepower
A.tension load twice each crankshaft revolution
B.compression load during power and compression strokes
C.inertia load once every four crankshaft revolutions
D.bending loads at bottom and top dead center
A.cooling water leaving each cylinder
B.fuel oil entering the injector
C.exhaust gases at various locations
D.lube oil at the bearing supplies
A.low water in the expansion tank
B.improperly seated valves
C.low fuel oil pressure
D.worn or broken cylinder liner sealing rings
A.exhaust
B.fuel oil
C.cooling water
D.cylinder liner
最新試題
To proceed to the assistance of a ship in distress is（）
For a given exhaust gas boiler, what is the quantity of its evaporation mainly determined?（）
Flame failure in an automatically fired auxiliary boiler can from a/an （）
When does auxiliary burner of incinerator put into operation? （）Ⅰ. start incinerator when it is coldⅡ. the sludge for dealing with is littleⅢ. the sludge for dealing with is largeⅣ. the water and impurity in sludge are too muchⅤ. the temperature in incinerator is lowⅥ. dealing with little solid rubbish
One of the reasons that cause oil flowed from sludge outlet of a self-cleaning separator is（）
Diesel engine air start system check valves are opened by （）
To shut down a diesel engine after it exceeds the set maximum speed，which type of device listed should be used?（）
（） is not installed on the main switchboar.
Thermostatic steam pressure reducing valves are used in the fuel oil service system to control the（）
Which of the following items don’t belong to dock repair works?（）