A.regulating the ratio between torque and speed via the torque limiter at the motor
B.directing the motor output flow through a bypass line
C.maintaining a constant flow and pressure input
D.controlling the input flow rate
您可能感興趣的試卷
你可能感興趣的試題
A.the temperature of the hydraulic fluid
B.the flow rate of the hydraulic fluid
C.the temperature of the cooling water
D.all of the above
A.regulate the fluid flow in either direction
B.restrict movement of hydraulic fluid in one direction, but allow free movement in the other direction
C.allow free movement of hydraulic fluid in both directions
D.allow a restricted fluid flow in one direction only
A.adding small amounts of oil to the system
B.the system has been overheated
C.the system has been drained and then filled with new oil
D.the system has been idle for a long period of time
A.permanent loss of pump suction
B.worn shaft seals
C.high level in the oil sump
D.low motor RPM
A.an improper rudder response
B.hammering noises in the equipment or transmission lines
C.popping or sputtering noises
D.all the above
最新試題
One of the reasons that cause oil flowed from sludge outlet of a self-cleaning separator is()
As soon as a diesel engine has started, which of the listed engine operating parameters should be checked FIRST?()
Diesel engine air start system check valves are opened by ()
When does auxiliary burner of incinerator put into operation? ()Ⅰ. start incinerator when it is coldⅡ. the sludge for dealing with is littleⅢ. the sludge for dealing with is largeⅣ. the water and impurity in sludge are too muchⅤ. the temperature in incinerator is lowⅥ. dealing with little solid rubbish
Engine parameters shall be corresponded to NOx Technical Files. This is required by ()
Cold weather starting of a diesel engine may be made easier by()
()are used to digest the sewage to produce innocuous sludge in a biological sewage treatment plant.
To proceed to the assistance of a ship in distress is()
Which of the following items don’t belong to dock repair works?()
By comparing the exhaust gas temperature of each cylinder, the operator can determine if the load is balanced throughout the engine. The device most commonly used is a()