A.cooling water
B.cooling oil
C.refrigerant
D.lubricate oil
您可能感興趣的試卷
你可能感興趣的試題
A.nuts
B.screws
C.studs
D.flanges
A.The alternators are not generating the same voltages and should be adjusted on automatic voltage regulator rheostats
B.Alternator frequencies are different and should be adjusted on the governor speed controllers
C.Alternators are out of phase and should be tripped and paralleled again
D.One alternator has lost one of its phases
A.high input impedance, high gain and low output impedance
B.high input impedance, high gain and high output impedance
C.low input impedance, low gain and high output impedance
D.low input impedance, high gain and low output impedance
A.methyl chloride
B.ammonia
C.hydrofluoric acid
D.ozone
A.one valve seats upwards, while the other seats downwards
B.the reed valves used on the discharge are made substantially thicker and heavier than the suction valves
C.the suction valve springs exert a greater tension than the discharge valve springs
D.the discharge valve springs exert a greater tension than the suction valve springs
最新試題
“Insufficiency of manning or insufficiency of certification of seafarers” is an identification of a()
One of the reasons that cause oil flowed from sludge outlet of a self-cleaning separator is()
The Port State Control officer may witness a fire drill carried out by the crew assigned to these duties on the()
Which of the listed governor characteristics will greatly affect the load sharing relationship between paralleled diesel generators?()
Diesel engine air start system check valves are opened by ()
The shipboard oil pollution emergency plan will be invalid after ()
When does auxiliary burner of incinerator put into operation? ()Ⅰ. start incinerator when it is coldⅡ. the sludge for dealing with is littleⅢ. the sludge for dealing with is largeⅣ. the water and impurity in sludge are too muchⅤ. the temperature in incinerator is lowⅥ. dealing with little solid rubbish
()connectors hold best if a wire is accidentally pulled or a connection becomes loose.
The ISPS Code consists of a mandatory section-Part A, which shows()
By comparing the exhaust gas temperature of each cylinder, the operator can determine if the load is balanced throughout the engine. The device most commonly used is a()