Refer to the exhibit. When applying this hierarchical policy map on the on the tunnel1 interface, you measure high jitter for traffic going through class 1234. What is the most likely cause of this jitter?()
A.The configuration of a hierarchical policy map on a tunnel interface is not supported.
B.Class 5555 and class 5554 are both taking up 100% of the bandwidth,leaving nothing for class 1234.
C.The burst size for the traffic shaping is wrongly configured to 15000;this would require an interface capable of sending at 150Mb/s.
D.The burst size for the traffic shaping has been wrongly configured;it should be set as low as possible.
E.The burst size for the traffic shaping has been wrongly configured;it should be set as high as possible.
您可能感興趣的試卷
你可能感興趣的試題
A.data marked with DSCP AF21,VOIP marked with DSCP EF
B.data marked with DSCP AF51,VOIP marked with DSCP EF
C.data marked with the DE-bit,VOIP marked with the CLP-bit
D.data marked with DSCP EF,VOIP marked with DSCP AF31
E.data marked with IP precedence 5 VOIP marked with DSCP EF
A.mark VOIP traffic with IP precedence 6 and configure only ’fair-queue’ on the links
B.configure the scheduler allocate 3000 1000 command to allow the QoS code to have enough CPU cycles
C.enable class-based traffic shaping on the VoIP traffic class
D.enable Layer 2 fragmentation and interleaving on the links
E.enable Frame Relay on the links and send voice and data on different Frame Relay PVCs
根據R2上面的配置,請判斷pc能否反問internet。
R2:ip route 0.0.0.0 0.0.0.0 10.1.1.2
No ip classess
A.Guaranteed PHB
B.Class-Selector PHB
C.Reserved Forwarding PHB
D.Discard Eligible PHB
E.Priority PHB
最新試題
The Frame Relay network in the diagram is not functioning properly.What is the cause of the problem?()
aaa架構中哪個是要求用戶輸入用戶名和密碼?
what is four ospf area type?
如何實現擁塞避免?
What is method list for configure aaa?
hsrp speak狀態是什么意思?
一堆交換機一個server、一個transpare,問配置prune在哪里配置?
When upgrading the IOS image,the network administrator receives the exhibited error message.What could be the cause of this error?()
Refer to the exhibit.What is the meaning of the term dynamic as displayed in the output of the show frame-relay map command shown?()
R1 will choose which path to reach 10.1.0.0?