A Host connected to an NPV switch is not able to see the storage connected to the core switch. Given the output of the show command below， what is the reason of this issue？（）
switch# show npv status
npiv is enabled
External Interfaces：
===============
InterfacE. fc1/1， VSAN： 1， FCID. 0x000000， StatE. Other
Number of External Interfaces： 4
A. NPV is not enabled on the core switch？
B. The interface connected to the Core switch is in admin down state
C. The local host interface belongs to the wrong VSAN？
D. The local host interface is not able to login
您可能感興趣的試卷
你可能感興趣的試題
A. The switch receives the FCoE frame and forwards it to another switch over its VE port.
B. The switch receives the FCoE frame， deapsulates it， and sends the Fibre Channel frame to the fabric over its Fibre Channel uplink port.
C. The switch receives the FCoE frame， deapsulates it， and sends the Fibre Channel frame to the Fibre Channel target over its Fibre Channel port.
D. The switch receives the FCoE frame and forwards it to another FCoE device over its VN port.
A. Up to 25 m bus length
B. Only one device per SCSI bus
C. Up to 16 devices per SCSI bus
D. Half-duplex operation
E. Full-duplex operation
A. Ethernet FCS
B. Source address
C. Destination address
D. EtherType
E. Protocol type
A. It is required to establish the point-to-point FCoE links with the first switch in the path.
B. It is required to establish the point-to-point FCoE links with any switch across multiple Ethernet segments.
C. It is not used to build the FCoE links.
D. It is used to ensure lossless transport.
A. Fibre Channel ports must be configured from the first port in the module.
B. Ethernet ports must be configured from the last port in the module.
C. Fibre Channel ports must be configured from the last port in the module.
D. Ethernet ports must be configured from the first port in the module.
最新試題
What is the purpose of this command in a Cisco Application Control Engine？（） switch/Admin# show np 1 me-stats "-F0 v"
Given the following output： san-port-channel 12 is up Hardware is Fibre Channel Port WWN is 24：0c：00：0d：ec：d3：5c：00 Admin port mode is NP， trunk mode is on Port mode is NP Port vsan is 1 Speed is 8 Gbps Member[1] ： fc2/3 Member[2] ： fc2/4 What does "Speed is 8 Gbps" indicate？（）
Your company wants Server 1/eth0 （vNIC 1） configured so that it always uses Fabric Interconnect A Port Channel 1 （Po1） when it communicates with anything outside of the Cisco UCS domain. However， if vNIC 1 fails over to Fabric Interconnect B using fabric failover， then vNIC 1 can any uplink port on Fabric Interconnect B. Which statements are true？ （）
Given a Cisco Unified Computing System， which is a valid port type in end-host mode？（）
A Cisco UCS fabric interconnect in end-host mode learns MAC addresses on which port types？（）
In the event of a GSS failure in a GSS cluster， which is true？（）
What is the appliance port used to connect to in a Cisco Unified Computing System？（）
In a Cisco Unified Computing System， where are SAN port channels connected to？（）
Which statements are true regarding the Cisco UCS fabric failover feature？ （）
Refer to the exhibit.The Cisco UCS domain is operating in switching mode. A network administrator notices that no traffic is traversing the uplinks on Fabric Interconnect B （Path C）. Which actions might be used to change this behavior？（）