The Company core switches use 802.1Q trunks to connect to each other.
How does 802.1Q trunking keep track of multiple VLANs？ （）
A. It tags the data frame with VLAN information and recalculates the CRC value
B. It encapsulates the data frame with a new header and frame check sequence
C. It modifies the port index of a data frame to indicate the VLAN
D. It adds a new header containing the VLAN ID to the data frame
E. None of the other alternatives apply
您可能感興趣的試卷
你可能感興趣的試題
Two Company switches are connected via a trunk link. In this network， the original frame is encapsulated and an additional header is added before the frame is carried over a trunk link. At the receiving end， the header is removed and the frame is forwarded to the assigned VLAN.
This describes which technology？（）
A. DISL
B. ISL
C. DTP
D. IEEE 802.1Q
E. MPLS
F. None of the other alternatives apply
When the Catalyst switch R1 is enabled to use VTP，
which information does it advertise on its trunk ports？（）
A. VTP mode
B. STP root status
C. Negotiation status
D. Management domain
E. Configuration revision number
Switch R1 is configured with VTP.
Which two VTP modes will make R1 capable of creating and deleting VLANs on itself？ （）
A. Client
B. Server
C. Transparent
D. Pass-through
E. No-negotiate
What action should you execute if you wanted to enable VTP pruning on your entire management domain？（）
A. Enable VTP pruning on any client switch in the management domain.
B. Enable VTP pruning on any switch in the management domain.
C. Enable VTP pruning on every switch in the management domain.
D. Enable VTP pruning on a VTP server in the management domain.
E. Disable VTP pruning on a VTP server in the management domain.
A.It does not prune traffic from VLANs that are pruning-ineligible
B.VLAN 1 is always pruning-eligible
C.It will prune traffic from VLANs that are pruning-ineligible
D.VLAN 2 is always pruning-ineligible
E.None of the other alternatives apply
最新試題
Refer to the exhibit. Switch 15 is configured as the root switch for VLAN 10 but not for VLAN 20. If the STP configuration is correct， what will be true about Switch 15？（）
Refer to the exhibit. For what purpose is the command show ip cef used？（）
During routine maintenance， G1/0/1 on DS1 was shutdown. All other interface were up. DS2 became the active HSRP device for Vlan101 as desired. However， after G1/0/1 on DS1 was reactivated. DS1 did not become the active HSRP device as desired. What need to be done to make the group for Vlan101 function properly ？ （）
What two things will occur when an edge port receives a BPDU？（）
Which three statements are true of the Link Aggregation Control Protocol （LACP）？（）
Refer to the exhibit. What does the command channel-group 1 mode desirable do？ （）
Refer to the exhibit. LACP has been configured on Switch1 as shown. Which is the correct command set to configure LACP on Switch2？（）
Refer to the exhibit. Initially， LinkA is connected and forwarding traffic. A new LinkB is then attached between SwitchA and HubA. Which two statements are true about the possible result of attaching the second link？（）
Refer to the exhibit. Based on the output of the show spanning-tree command， which statement is true？ （）
What will occur when a nonedge switch port that is configured for Rapid Spanning Tree does not receive a BPDU from its neighbor for three consecutive hello time intervals？（）