多項選擇題

VOIP is being implemented in the Company network and you need to assess the need for QoS.  
Which of the following network problems would indicate a need to implement QoS features?()

A.Mis-routed packets  
B.Excess jitter
C.Delay of critical traffic
D.Packet loss due to congestion
E.Data link layer broadcast storms
F.FTP connections unsuccessful


您可能感興趣的試卷

你可能感興趣的試題

2.單項選擇題

Jitter is causing problems with the VOIP application in the Company network. 
What causes  network jitter?()

A.Variable queue delays
B.Packet drops
C.Transmitting too many small packets
D.Compression

3.單項選擇題

Refer to the exhibit. A trunk link is connected between switch A_SW and switch D_SW. Based on  the configuration shown in the exhibit, 
how would the traffic coming from the switch A_SW be  managed? ()

A.The trunk port Fa0/1 on switch A_SW will trust allCoS values on the frames coming from the IP  phone.
B.The trunk port Fa0/1 on switch A_SW will trust allCoS values on the frames received on the IP  phone.
C.The trunk port Fa0/1 on switch D_SW will trust allCoS values on the frames coming from port  Fa0/1 on A_SW.
D.The trunk port Fa0/1 on switch D_SW will trust allCoS values on the frames received on the  A_SW switch port Fa0/4.
E.The trunk port Fa0/1 on switch D_SW will trust allCoS values on the frames received on the IP  phone port.

4.單項選擇題

Refer to the exhibit. 
Which statement is true when voice traffic is forwarded on the same VLAN  used by the data traffic? ()

A.The voice traffic cannot be forwarded to the distribution layer.
B.The voice traffic cannot use 802.1p priority tagging.
C.Port security cannot be enabled on the switch that is attached to the IP phone.
D.Quality of service cannot be applied for the voice traffic.

5.單項選擇題

Refer to the exhibit.
 Why does the trust state of interface FastEthernet 0/3 show "not trusted"?  ()

A.DSCP map needs to be configured for VOIP.
B.ToS has not been configured.
C.ToS has been misconfigured.
D.The command mls qos needs to be turned on in global configuration mode.
E.There is not a Cisco Phone attached to the interface.

最新試題

Refer to the exhibit. For what purpose is the command show ip cef used?()

題型:單項選擇題

If G1/0/1 on DS1 is shutdown, what will be the current priority value of the Vlan105’s group on DS1 ?()

題型:單項選擇題

During routine maintenance, G1/0/1 on DS1 was shutdown. All other interface were up. DS2 became the active HSRP device for Vlan101 as desired. However, after G1/0/1 on DS1 was reactivated. DS1 did not become the active HSRP device as desired. What need to be done to make the group for Vlan101 function properly ? ()

題型:單項選擇題

What will occur when a nonedge switch port that is configured for Rapid Spanning Tree does not receive a BPDU from its neighbor for three consecutive hello time intervals?()

題型:單項選擇題

Refer to the exhibit. LACP has been configured on Switch1 as shown. Which is the correct command set to configure LACP on Switch2?()

題型:單項選擇題

Refer to the exhibit. The command switchport mode access is issued on interface FastEthernet0/13 on switch CAT1. What will be the result?()

題型:單項選擇題

What two things will occur when an edge port receives a BPDU?()

題型:多項選擇題

What is the configured priority value of the Vlan105’s group on DS2 ?()

題型:單項選擇題

Which three statements about STP timers are true?()

題型:多項選擇題

Which router redundancy protocol cannot be configured for interface tracking?()

題型:單項選擇題