During the installation of the cisco wcs version 4.0，an error occurs.
Where would you look for the installation log，in order to learn more about this error？（）
A.at the root of the installation drive
B.in the cisco wcs installation directory
C.on the desktop of the server
D.in the cisco wcs\logs directory
您可能感興趣的試卷
你可能感興趣的試題
You are configuring an rf group of controllers that coordinate radio resource management calculations.
What is the maximum number of wlan controllers that you can add？（）
A.17
B.20
C.12
D.24
When configuring a wlan controller for a voice application using cisco 7920 wireless ip phones.
which two general control settings should you select？（）
A.multicast on
B.aggressive load balancing off
C.multicast off
D.ap fallback on
E.aggressive load balancing on
F.ap fallback off
You are installing a cisco 4402 series wireless lan controller.
Which type of interface should you use on the controller’s distribution port？（）
A.1000base-sx sfp
B.10/100/1000 mbps rj45
C.10/100 mbps rj45
D.10000base-sx
By default，on the wlan controller for a voice application using cisco 7921 wireless ip phones.
what is the percentage of rf bandwidth that can be dedicated to the phones？（）
A.75 percent
B.85 percent
C.56 percent
D.55 percent
A.clients connected to the rogue access point must be able to connect to the containment controller-based access point.
B.multiple controller-based access points will load-balance the containment task using fewer resources than a single access point.
C.clients connected to the rogue access point may be out of the range of the controller-based access point providing containment.
D.each controller-based access point can handle only a limited amount of clients connected to the rogue access points.
最新試題
The IOS of a North American Cisco Aironet 1130AG Series standalone access point has becomecorrupt. You must therefore reload the TFTP firmware.Before you press and hold the MODEbutton， you should verify that the file name is which of the following？（）
When configuring a WLAN controller for a voice application using Cisco 7920 wireless IP phones，which two general control settings should you select？（）
On a WLAN controller， what is the default roaming bandwidth percentage reserved for voice clients？（）
You have been called upon to add location-based services into an existing controller-basedwireless design which primarily encompasses handheld devices such as barcode scanners and Cisco7920 wireless IP phones.In which mode should you deploy the additional access points to achievethe density required without excessive co-channel interference？（）
Static WEP is configured on the access point. You are authenticated and associated to the accesspoint but are unable to obtain an IP address.Which of the following will cause this problem？（）
When configuring Cisco Secure ACS to support wireless EAP authentication， which device must be configured as a AAA client？（）
You are troubleshooting a problem with a Cisco 7920 wireless IP phone that is causing the phoneto drop calls. The problem appears to be roaming bandwidth issue. In order to verify what kind ofissue it is， you decide to increase the bandwidth reserve for roaming on the WLAN controller tomaximum.What level do you set the bandwidth to？（）
You review the Failed Attempts logs on an AAA server and find： "unknown network access servererror." Which failure could produce this error？（）
You have just finished aligning a Cisco Aironet 1400 Series Wireless Bridge link using installationmode. When you set the link back to operational mode you loose association to the root bridge.Which action will correct the problem？（）
You are configuring an RF group of controllers that coordinate Radio Resource Management calculations.What is the maximum number of WLAN controllers that you can add？（）