A.more access points than a data network
B.fewer access points than a data network
C.less SNR than a data network
D.specific relative access point placement
您可能感興趣的試卷
你可能感興趣的試題
A.omnidirectional
B.patch
C.Yagi
D.sector
E.parabolic dish
A.Alternate polarization between colocated antennas
B.Cross-polarize antennas between endpoints
C.Install an RF-shielded box around the antennas
D.Increase the distance between the antennas
A.-65 dBm
B.-67 dBm
C.-69 dBm
D.-70 dBm
A.PNG
B.JPEG
C.GIF
D.BMP
E.PICT
F.TIFF
A.AIR-ANT3213
B.AIR-ANT2465P-R
C.AIR-ANT1949
D.AIR-ANT5160V-R
最新試題
When using a lightning arrestor, connect which type of ground wire to a good earth ground?()
What is the minimum recommended access point overlap for voice roaming?()
Which statement about active and passive surveys is incorrect?()
According to the following statement, can you tell me which term is described?()It is the air return for an air conditioned system. In most buildings, the area above a drop ceiling orunder a raised floor is used as the air return (source of air) for the air conditioning. Those dropceiling and raised floors are also where wire is often installed. If wire and cable is installed in a dropceiling or raised floor, it is out of sight. If that cable were burning, it would give off toxic fumes.These would be fed to the rest of the building by the air conditioner. As a result, people could beinjured even though they are a long way from the fire.
When planning for voice deployments with the Cisco Unified Wireless IP Phone 7921G handset in amultifloor building with a WLAN that operates at an 11 MB/s data rate, how many decibelsreferenced to 1 milliwatt of same-channel separation are recommended between floors?()
Given the correct input parameters, the Cisco WCS Planning Tool can calculate a recommendedaccess point count for which three uses? ()
Which three items does the Cisco WCS Planning Tool Generate Proposal Report provide?()
What will cause wireless voice devices to perform poorly?()
Which can NOT be selected for supported services in Cisco WCS Planning Tool?()
Cisco recommends a decibel referenced to 1 milliwatt signal level for the coverage cell edge at thepredetermined data rate that is needed to support the VoWLAN device and call capacityrequirements. What is that signal level value for Cisco Unified Wireless IP Phones 7920, 7921G, and7925G?()