Click the Exhibit button.
Which type of multiplexer is shown in the exhibit？（）
A. Thin Film filter
B. Fiber Bragg Grating
C. Arrayed Wave Guide
D. Erbium fiber amplifier
您可能感興趣的試卷
你可能感興趣的試題
A. fiber dispersion
B. signal attenuation
C. transmitter power
D. amplifier bandwidth
E. receiver dispersion tolerance
A. 0 ps/nm
B. 340 ps/nm
C. 200 ps/nm
D. 3400 ps/nm
E. More information is needed.
A. The glass core is doped with an Erbium in periodic segments of the fiber.
B. Layers of high index ？and low index ？material are deposited on a glass substrate.
C. Thin layers of silica glass are placed onto wafers to produce a prism-like effect.
D. Fiber is etched with an ultraviolet laser that is precisely spaced for specific wavelength filtering.
Click the Exhibit button. When designing a DWDM system with multiple amplified spans， a pre-amp is needed at Site B to （）.
A. offset the OADM loss at site B
B. overcome the high multiplexer loss at site A
C. amplify signal levels after the high loss through Fiber Span 1
D. adjust add channels at site B to be at the same level as the passthrough channels
E. ensure that the per channel power is higher than the minimum needed for the post-amp at Site B
In the OSNR model for EDFA amplifiers， SNR OUT = 1/（1/SNR IN + FhvB/P IN ），
what does SNR IN represent？（）
A. the signal to noise of the current optical amplifier
B. the signal to noise of the previous amplifier or source
C. the signal to noise introduced by the optical multiplexer
D. the accumulated noise to signal ratio of the optical channel
最新試題
Click the Exhibit button. Within an ONS 15454， you are provisioning a circuit on an unprotected SNCP ring. In the exhibit， which two must you configure？（）
A VC-4-4c consists of （）.
On an ONS 15454 node you can tunnel a（n） （）.
If the dispersion of a given fiber is 17ps/nm*km at 1550 nm and zero at 1310 nm， then what is the accumulated dispersion of an ITU wavelength after it travels 200 km？ （）
What is the difference between the transmitted power and the sensitivity of the receiver？ （）
Which timing mode is appropriate for an SDH NE that is adjacent to an SDH NE Bits-1 timing？ （）
A 2.5 Gb/s （OC-48 or STM-16） optical signal with a dispersion tolerance of 1200 ps/nm goes through fiber with 18ps/nm*km of dispersion. How many 15216-DCU-350 equivalents are needed for enough compensation after traveling 100 km？（）
If the power is 0 dBm， what is the power in mW？（）
What three in combination are factors that can cause four-wave mixing in fiber-optic cables？（）
In order to avoid misconnections due to a failed node in an MS-SPRing， Alarm Indication Signals （AISs） are sent on every channel normally terminating in that node. What is the name of this process？（）