A.an electric system manager
B.a sensing bulb at the tail coil of the evaporator
C.pressure changes in the suction line
D.failure of the king solenoid valve
您可能感興趣的試卷
你可能感興趣的試題
A.fluid friction
B.fluid turbulence
C.component misalignment
D.pressure surges
A.refrigerant must be bled off the sensing line before adjustments are made
B.all refrigerant must be pumped into the receiver before adjustments are made
C.time must be allowed for conditions to stabilize in the evaporator before further adjustments are made
D.all refrigerant must be routed through the dehydrator while changing the superheat setting
A.motor controller overload would open
B.pump would eventually overheat
C.relief valve would continuously cycle open
D.motor would overheat
A.have a greater head capacity
B.operate with increased impeller efficiency
C.discharge through the suction side of the pump casing
D.require more power to run the shaft
A.hydraulic fluid contamination
B.excessive fluid friction
C.turbulent fluid flow
D.fluid pressure surges
最新試題
The rate of heat transfer between the hot and cold fluids passing through a shell-and-tube type heat exchanger will ().
If the suction pressure at the refrigeration compressor is below normal, the cause can be().
If the thermal bulb of an expansion valve is incorrectly placed at the center of the coil instead of the end, it will ().
The general purpose of a heat exchanger is to ().
The usual symptoms of cavitation in a centrifugal pump is ().
A grease gun is generally used to lubricate a ().
On tank vessels equipped with power operated cargo tank valves, the type of power operator most commonly used is ().
Which of the listed pumps is NOT a positive displacement pump?()
When a refrigeration compressor has developed a high head pressure as a result of a refrigerant overcharge, you should ().
The control mode in which the final control element is moved from one of two flexed positions to the other is known as ().