單項選擇題After the show ip route command has been entered,the follwing routes are displayed.Which route will not be entered into the routing table of a neighboring router?()

A. R 192.168.8.0/24 [120/1] via 192.168.2.2, 00:00:10, Serial0
B. R 192.168.11.0/24 [120/7] via 192.168.9.1, 00:00:03, Serial1
C. C 192.168.1.0/24 is directly connected, Ethernet 0
D. R 192.168.5.0/24 [120/15] via 192.168.2.2,00:00:10,Serial0


您可能感興趣的試卷

你可能感興趣的試題

1.單項選擇題What is the subnetwork address for a host with the IP address 201.100.5.68/28?()

A. 201.100.5.0
B. 201.100.5.32
C. 201.100.5.64
D. 201.100.5.65
E. 201.100.5.31
F. 201.100.5.1

2.單項選擇題Which statement describes the rule of split horizon?()

A. Only router can split boundaries(horizons)between concentric networks.
B. All distance vector protocols require fall routes that may cause momentary loops as the topology changes.
C. Networks can only remain fully converged if all information about routes is sent out all active interfaces.
D. Information about a route should not be sent back in the direction from which the original update came.
E. Each AS must keep routing tables converged to prevent dead routes from being advertised across the AS boundary.

3.單項選擇題While troubleshooting a network problem,a technician discovers that the current copy of the Cisco IOS is outdated and needs to be updated.Which of the following commands would the technician issue to replace the Cisco router IOS with the newer version?()

A. Router#copy tftp flash
B. Router(config)#restore flash
C. Router(config)#repair flash
D. Router#copy flash run
E. Router>copy start flash
F. Router#copy start flash

5.單項選擇題An administrator must assign static IP addresses to the servers in a network.For network 192.168.20.24/29, the router is assigned the first usable host address while the sales server is given the last usable host address. Which of the following should be entered into the IP propertied box for the sales server?()

A. IP address:192.168.20.14 Subnet Mask:255.255.255.248 Default Gateway:192.168.20.9
B. IP address:192.168.20.254 Subnet Mask:255.255.255.0 Default Gateway:192.168.20.1
C. IP address:192.168.20.30 Subnet Mask:255.255.255.248 Default Gateway:192.168.20.25
D. IP address:192.168.20.30 Subnet Mask:255.255.255.240 Default Gateway:192.168.20.17
E. IP address:192.168.20.30 Subnet Mask:255.255.255.240 Default Gateway:192.168.20.25

最新試題

Which statement describes the rule of split horizon?()

題型:單項選擇題

After the show ip route command has been entered,the follwing routes are displayed.Which route will not be entered into the routing table of a neighboring router?()

題型:單項選擇題

Which command displays the CHAP authentication process as it occurs between two routers?()

題型:單項選擇題

The network administrator cannot to switch 1 over a telnet session,although the hosts attached to switch 1 can ping the interface Fa0/0 of the router.Given the information in the graphic and assuming that the router and switch2 are configured properly,which of the following commands should be issued on switch 1 to correct this problem?()

題型:單項選擇題

At which layer of the OSI model dose PPP perform?()

題型:單項選擇題

Which pairing reflects a correct protocol-and-metric relationship?()

題型:單項選擇題

An employee of ABC company has move to an office on a different floor. Although the administrator is able to telnet to all of the routers,the address of Switch F is needed in order to verify that the employee remains in the same VLAN.Which action could be used by the administrator to find the IP address of Switch F?()

題型:單項選擇題

An administrator must assign static IP addresses to the servers in a network.For network 192.168.20.24/29, the router is assigned the first usable host address while the sales server is given the last usable host address. Which of the following should be entered into the IP propertied box for the sales server?()

題型:單項選擇題

Which encapsulation type is a Frame Relay encapsulation type that is supported by Cisco routers?()

題型:單項選擇題

Which command is used to display the collection of OSPF link states?()

題型:單項選擇題